Note
If your hard disk drive has a partition larger than 32MB and
you are using MS-DOS, you must use the MS-DOS SHARE
command to install file sharing and locking protection in a
network environment. See your MS-DOS manual for
instructions.
If you do not install SHARE, the following message flashes
on your screen after you install your network software and
reboot your computer:
WARNING! SHARE should be loaded
for
large media
Using a Password in Network Server Mode
When you turn on or reset the computer, it loads your
operating system or network software and you see either the
command prompt or the first screen displayed by your
network software.
Follow these steps to enter your password:
1.
Turn on or reset your computer. You do not see the password
prompt even though the computer is now waiting for you
to enter the correct password.
2.
Type your password and press
I.
The screen does not
display what you type.
Now you should be able to use your computer. Press a key
such as
m
to see if the keyboard accepts your command. If
you entered an incorrect password, the computer does not
respond. Type the correct password, press
li
Enlw
,
and try using
the computer again.
2-8
Enhancing System Operations