Filter
Top Products
q The escape sequence for font selection is ESC f N.
q Selecting or canceling proportional spacing is not supported.
q Disabling the paper-out detection is not supported.
Motion Indexes
The Model 855 WP emulation mode uses motion indexes to specify
certain horizontal and vertical parameters. These motion indexes are
established by character pitch and line spacing commands described
later in this chapter.
The horizontal motion index and vertical motion index are abbreviated,
respectively, as HMI and VMI. Their definitions are as follows.
q HMI — The horizontal distance between two adjacent characters.
The HMI range is 0 through 254/120 (0 through 2.12) inches in
increments of 1/120 inch.
q VMI — The vertical distance between two adjacent print lines.
The VMI range can be either of the following, depending upon
the escape sequence used to establish the VMI.
— 0 through 84/48 (0 through 1.75) inches in increments of
1/48 inch
— 0 through 254/144 (0 through 1.62) inches in increments of
1/144 inch
TI Model 855 Printer WP Emulation 5-5