Filter
Top Products
21
Install the Network Software
To configure the Ethernet card, you need to install the network software (EPSON
Net!2) on only one workstation or on the server, depending on your network.
If you have a TCP/IP network, you need to install EPSON Status Monitor 2 on all
your Windows 98 and Windows 95 workstations to use the EPSON TCP/IP printing
protocol.
Log in as an Administrator (NT) or Supervisor (NetWare). Before you start, turn off
all other active applications, including virus protection programs.
If you need to create diskettes to install the software, see
page 103. Then follow the configuration instructions, starting
on page 26.
For TCP/IP networks, if you want to use the arp command to
set the card’s IP address instead of installing EPSON Net!2,
see page 42.
Installing EPSON Net!2
If you have the following network configurations and operating systems, you should
install EPSON Net!2 to configure the card:
■
Windows 98, Windows 95, or Windows NT 4.0 with Novell NetWare or
TCP/IP
■ Macintosh with AppleTalk
instconf.fm Page 21 Friday, February 19, 1999 4:00 PM