Filter
Top Products
79
Using the Control Panel
Follow these steps to clean the print head using the control panel:
1. Make sure the printer is turned on but not printing, and both the
B black and
A color ink out lights are off.
2. Press the
R cleaning button and hold it down for three seconds. Cleaning takes a
little over a minute, during which the printer makes some noise and the
P power
light flashes.
Never turn off the printer while the
P power light is flashing,
unless the printer hasn’t moved or made noise for more than
5 minutes.
3. After the
P power light stops flashing, print a page to test the print quality and
reset the cleaning cycle.
If you’re using Windows or Macintosh, run a nozzle check. Go to step 4.
If you’re using DOS, open an application and print a document containing black
and color data. Then go to step 8.
4. Start an application, open a document, and access the printer settings dialog box
as described in “Printing with Windows” on page 60 or “Printing with a
Macintosh” on page 64.
5. Click the
Utility tab (Windows) or the Utility icon (Macintosh). You see the
Utility menu.
6. Make sure paper is loaded in the printer, click the
Nozzle Check icon, and click
Next. The nozzle check pattern prints on the printer; see “Examining the Nozzle
Check Pattern” on page 80 for details.
7. If the nozzle check pattern is filled in completely, click
Finish.
If the pattern is missing dots, click
Clean to clean the print head again.
8. If you don’t see any improvement after cleaning two or three times, check the
solutions in “Problems Getting Good Print Quality” on page 93.
maint.fm Page 79 Friday, February 19, 1999 4:02 PM