Filter
Top Products
Installing or Removing a Drive
Before you perform the following steps, be sure to set the
jumpers on any IDE hard disk drive(s) you may be installing.
See page 6-3 for instructions.
Follow these steps to install or remove an internal drive:
1.
If you need to remove a drive, remove the screws securing
it to the housing; there are two screws on each side. Then
grasp the drive from the front and pull it out of the
housing.
If you do not need to install a drive, go to step 4.
2.
To install a new drive (or reinstall a drive you removed),
position the housing as shown in the next illustration and
slide in the drive.
6-16
Irzstdling
nnd
RenrozGng
Disk Drives