Filter
Top Products
2.
Remove the two screws securing the drive to the drive bay, as
shown below. Then pull the drive out from the front of the
bay and set it aside.
3.
If you removed your only IDE hard disk drive from the
computer, you must remove the internal drive housing so
you can disconnect the hard disk drive cable from the main
system board. See “Removing the Internal Drive Housing”
on page 6-14 for instructions.
4.
If you removed one IDE drive and left another one in the
computer, you must also remove the remaining drive and
set its jumpers to indicate that you now have only one IDE
drive installed. Perform steps 1 and 2, above, to remove the
drive from an upper bay or see page 6-13 to remove it from
the internal drive housing. Then see page 6-3 for
instructions on changing the jumper settings.
5.
If necessary, replace the slot cover in the front panel for the
drive you removed.
6-8
Installing and Removing Disk Drives