Filter
Top Products
3.
Align the holes on each side of the drive with the two holes
on each side of the housing and secure the drive with the
four retaining screws that came with the drive.
Note
If you are installing a half-height drive, insert the drive
at the top or bottom of the housing to leave room for a
second half-height drive, in case you want to install one
later.
4.
If you removed one IDE hard disk drive and left another one
in the computer, you must also remove the remaining drive
and set its jumpers to indicate that you now have only one
IDE drive installed. Perform step 1, above, to remove the
drive from the internal housing or see page 6-7 to remove
the drive from an upper drive bay. Then see page 6-3 for
instructions on changing the jumper settings.
5.
Now reinstall the internal drive housing as described below.
Installing and Removing Disk Drives
6-17