Filter
Top Products
7.
Align the hard disk drive cable connector with the drive
socket so the row in the connector with the blocked hole
lines up with the row in the socket with the missing pin, as
shown below. Then push in the connector.
blocked hole
Now go to step 9.
8.
If you are connecting diskette drive A, use the drive
connector labelled FDD1 on the end of the diskette drive
cable. If you are connecting drive B, use the connector
labelled FDD2. If you installed a tape drive, use the
connector labelled TAPE DRIVE ONLY.
Align the connector with the drive interface so that the
divider in the connector lines up with the gap in the
interface, as shown in the following illustration. Then push
in the connector.
6-12
Insfalli~zg
ad
Removing Disk Drives