Filter
Top Products
Safety Instructions 15
❏ Be careful not to touch the fuser, which is marked CAUTION
HOT SURFACE and CAUTION HIGH TEMPERATURE, or the
surrounding areas. If the printer has been in use, the fuser and
the surrounding areas may be very hot. If you must touch one
of these areas, wait 40 minutes to allow the heat to subside
before doing so.
a. CAUTION HOT SURFACE
b. CAUTION HIGH TEMPERATURE
❏ Do not insert your hand deep into the fuser unit as some
components are sharp and may cause injury.
❏ Avoid touching the components inside the printer unless
instructed to do so in this guide.
❏ Never force the printer’s components into place. Although the
printer is designed to be sturdy, rough handling can damage
it.
❏ When handling an imaging cartridge, always place it on a
clean, smooth surface.
❏ Do not attempt to modify an imaging cartridge or take it apart.
It cannot be refilled.
ba