Filter
Top Products
5 • Maintenance
114
4. Use a screwdriver, coin, or similar object to loosen the two
screws holding the lamp assembly in position. (You cannot
remove these screws.)
✦
Caution:
Do not touch the glass portion of the lamp assembly;
this can cause premature lamp failure.
5. Lift up the handle and pull out the lamp assembly.
6. Gently insert the new lamp assembly by lowering it into
position. Make sure it’s inserted securely. Tighten the screws on
the new lamp assembly.
7. Replace the lamp cover and tighten the cover screw. (Make sure
the lamp cover is securely fastened. The projector will not run if
the lamp cover is open.)
2
1
5500.book Page 114 Wednesday, August 4, 1999 4:41 PM