Filter
Top Products
Turning the Equipment On and Off
41
Turning the Equipment On and Off
It’s best to turn on the projector and its attached equipment in the
following order:
1. Video source (such as a VCR), if your video source is not your
computer
2. Audio source (if different from computer or video source)
3. External amplified speaker or PA system (if necessary)
4. Computer
5. Projector (see instructions below)
When you are ready to turn off the equipment, do so in the reverse
order.
Turning the Projector On and Off
1. Remove the projector lens cap.
2. Connect one end of the power cord to the projector’s power
inlet, and connect the other end to a grounded electrical outlet.
3. Turn on the main power switch located at the rear of the
projector and wait until the power light remains orange.
4. Press the Power button on the remote control or control panel.
The power light flashes green as the projector warms up. When
the projector is fully warmed up, this light remains green.
5500.book Page 41 Wednesday, August 4, 1999 4:41 PM