Filter
Top Products
EPSON Imaging Technology Center Page: 31
Revision: 1 (Date: 6/20/00)
6.8 Set Paper Size “ ESC (S nL nH w1 w2 w3 w4 l1 l2 l3 l4”
Format:
ASCII ESC ( S nL nH w1.. w4 l1 l2 l3 l4
Hex 1B 28 53 nL nH w1.. w4 l1 l2 l3 l4
Dec. 27 40 83 nL nH w1.. w4 l1 l2 l3 l4
Range of Definition:
nL=08H, nH=00H
Function:
- Set (w4x256x256x256+w3x256x256+w2x256+w1) x (Page Control Units)
inches as the X direction paper width (actual width from the left to the right).
Set (l4x256x256x256+l3x256x256+l2x256+l1) x (Page Control Units) inches
as the Y direction paper length (actual length from the top to the bottom).
- The top margin and the bottom margin do not affect the page length.
- If the paper size is 0, it will be ignored as not specified.
- If it is set right after , or when paper is out, from the top of paper to the bottom
of paper is considered to be the paper length.
- If it is set not just after paper feeding, and when paper is in, from the setting
position to the bottom of paper is considered to be the paper length.
- This command can be used only during graphics mode, ESC (G.
Initial State: -
Related Commands:
- Commands related in the direction of applying an effect (Setting)
None
- Commands related in the direction of receiving an effect (Setting)
The page control setting unit is set by the ESC (U command.
- Commands related in the direction of applying an effect (Operation)
None
- Commands related in the direction of receiving an effect (Operation)
It reset to initial states by ESC @ and ESC (G commands.