Filter
Top Products
EPSON Imaging Technology Center Page: 47
Revision: 1 (Date: 6/20/00)
6.22 Set Pause After Printing “PZ” 02H 00H 00H m1
Format:
“PZ” 02H 00H 00H m1
Parameters:
Parameter m1 is one byte binary code, and indicates the state as follows:
Set Pause After
Printing
m1
Off 00H
On 01H
Reserved 02H - FFH
Function:
- The default pause state after printing is set.
- If the pause after printing is ON, the printer is stopped at the pause state after
the FF command is executed.
- If the auto cutting is set, it is pausing after cutting / printing horizontal lines.
- If parameter m1 is out of range, this command is ignored and the existing
setting is maintained.
- This command is only valid in remote mode.
Exception:
- If the banner mode is set, it processes after the LD command is executed and
not after the FF command.