Filter
Top Products
EPSON Imaging Technology Center Page: 54
Revision: 1 (Date: 6/20/00)
CHAPTER 7: SUPPLEMENT
7.1 Set Panel and Remote Command
This printer has a display operation panel, and each setting can be set by the panel or by
the remote commands. The following are the setting by the panel and by the remote
commands:
- The setting by the panel is saved as the default value of the printer.
- The setting value of remote commands is used for items to set by the driver
with remote commands.
- The default value of the printer is used for items not to set by the driver.
- The default value of the printer is loaded by LD commands (remote
commands), and the setting by remote commands is cleared.
- The driver sets the LD command and returns to the default value of the printer
after finishing job to clear the setting by the remote mode.
7.2 Select Paper Thickness
The driver sets the paper thickness to the printer by the paper thickness setting command.
The printer enhances the print quality using this thickness as data to calculate the gap of
the head - paper surface with each mode.
See Chapter 2
7.3 Auto cut ON/OFF
This function automatically cuts the roll paper with a cutter after the new page.
- If the sheet is selected, the selection of the auto cut is invalid.
- The printer operation by the setting of the auto cut depends on the
combination of the print page line function.
- The default setting of the auto cut is ON.
Table 12. Auto Cut/off mode
Auto Cut Page Line Printer Operation
Command Command
(Vertical Line)
00H 00H Nothing
00H 01H Print vertical lines
01H 00H Auto Cut
01H 01H Print vertical lines and auto cut
02H 00H Print horizontal line
02H 01H Print Page Line (vertical line,
horizontal line)
7.4 Print Page Line