Filter
Top Products
EPSON Imaging Technology Center Page: 34
Revision: 1 (Date: 6/20/00)
6.10 Set Absolute Vertical Print Position “ESC (V nL nH m1 m2 m3 m4 ”
Format:
ASCII ESC ( V nL nH m1 m2 m3 m4
HEX 1B 28 56 nL nH m1 m2 m3 m4
Decimal 27 40 86 nL nH m1 m2 m3 m4
Range of Definition:
nL=04H, nH=00H
0 <= (m4x256x256x256 +m3x256x256 + m2x256 + m1))x
(Absolute vertical position setting units) inch <= 1FFFFFFFH/1440 inch
Function:
- The printing position in the Y direction is set to a position spaced in the
positive direction from the present Y printing position in the Y direction by
(m4x256x256x256 + m3x256x256 + m2x256 + m1) x (Absolute vertical
position set unit) inches.
- If the printing position in the Y direction has been set by this command to a
non-printable region, then the paper is ejected, the position management
coordinate system is set to the next page, and the printing position is reset to
the origin of the new position management system. If the printing position in
the Y direction has been set by this command to a page other than the current
page, then the position management coordinate system is shifted to the
printable region upon that page, and the following position management is
performed upon the new position management coordinate system.
- Setting in the negative direction is ignored.
- This command is effective only for the graphic mode.
Initial State: -
Related Commands:
Commands related in the direction of applying an effect (Setting)
None
Commands related in the direction of receiving an effect (Setting)
None
Commands related in the direction of applying an effect (Operation)
None
Commands related in the direction of receiving an effect (Operation)
The Absolute vertical position setting units are set by the ESC (U command. The
non-printable region is set by the ESC (c commands. The absolute vertical
position setting units, the non-printable region, and the printing position in the Y
direction are reset to their initial states by the ESC @ and ESC (G commands.