Filter
Top Products
EPSON Imaging Technology Center Page: 35
Revision: 1 (Date: 6/20/00)
6.11 Set Relative Vertical Print Position “ESC (v nL nH m1 m2 m3 m4”
Format:
ASCII ESC ( v nL nH m1 m2 m3 m4
Hex 1B 28 76 nL nH m1 m2 m3 m4
Decimal 27 40 118 nL nH m1 m2 m3 m4
Range of Definition:
nL=04H, nH=00H
0 ≤ (m4x256x256x256 +m3x256x256 + m2x256 + m1))x(Relative vertical
position setting units) inch ≤ 1FFFFFFFH/1440 inch
Function:
- The printing position in the Y direction is set to a position spaced in the positive
direction from the present Y printing position by (m4x256x256x256 +
m3x256x256 + m2x256 + m1) x (relative vertical position setting units) inches.
- The setting in the negative direction is ignored.
- If the printing position in the Y direction has been set by this command to a
non-printable region, then the position management coordinate system is set to
the next page, and the printing position in the Y direction is reset to the origin
upon the Y-axis of the new position management coordinate system. If the
printing position in the Y direction has been set by this command to a page
other than the current page, then the position management coordinate system is
shifted to the printable region upon that page, and the following position
management is performed upon the new position management coordinate
system.
- This command is only effective in graphics mode.
Initial State: -
Related Commands:
Commands related in the direction of applying an effect (Setting)
None
Commands related in the direction of receiving an effect (Setting)
None
Commands related in the direction of applying an effect (Operation)
None
Commands related in the direction of receiving an effect (Operation)
The relative vertical position setting units are set by the ESC (U command.
The non-printable region is set by the ESC (c commands.
The relative vertical position setting units, the non-printable region, and the
printing position in the Y direction are reset to their initial states by the
ESC @ and ESC (G commands.