Filter
Top Products
Using the Control Panel
3-2
Lights
P The power light is on when the printer is on. It flashes while
receiving data, replacing the ink cartridge, or cleaning the print
heads, and in certain error conditions.
S On when there is no paper loaded or it’s loaded incorrectly.
Flashes if there is a paper jam or in certain error conditions.
B The black ink out light flashes when black ink is low or during
certain error conditions. It is on when the ink cartridge is empty
or not installed, or when there is a paper jam.
A The color ink out light flashes when color ink is low or during
certain error conditions. On when the ink cartridge is empty or
not installed, or when there is a paper jam.
For a list of error conditions indicated by the control panel
lights and solutions for correcting them, see Chapter 5.
Buttons
P The power button turns the printer on and off. It also resets the
printer (clears its memory) if you press it twice while the power
is on.
E The load/eject button loads or ejects a sheet of paper if you
press and release it within two seconds. (The printer normally
loads and ejects paper automatically.) When the printer is off
and you hold down the load/eject button while turning the
printer on, it runs a printer check. See the next section for
instructions.
R You use the cleaning button for replacing ink cartridges and
cleaning the print heads, based on the status of the ink out
lights. See Chapter 4 for details. When the printer is off and you
hold down the cleaning button while turning the printer on, it
changes the character table. See page 3-3 for instructions.
hw_ch3.fm5 Page 2 Friday, July 25, 1997 9:53 AM