Filter
Top Products
Maintenance and Transportation
4-7
Cleaning the Printer
1. Turn off the printer, unplug the power cord, and
disconnect the printer cable.
2. Remove all the paper from the sheet feeder.
3. Clean the exterior of the printer with a soft, damp cloth.
Keep the printer cover closed so water doesn’t get inside.
4. Clean ink out of the printer’s interior with a soft, damp
cloth.
Transporting the Printer
1. Turn on the printer and wait until the print heads lock in
the far right position. Then turn off the printer.
2. Unplug the power cord from the electrical outlet. Then
disconnect the interface cable from the printer.
3. Remove any paper from the sheet feeder, push in the paper
support extension, and remove the paper support.
4. Push in the output tray extensions and close the tray.
5. Repack the printer and attachments in the original box
using the protective materials that came with it. See the
Notice Sheet that was packed with the printer.
Be sure to keep the printer level as you transport it. If you
notice a decline in print quality after transporting the printer,
clean the print heads; if output is misaligned, align the print
heads. See the instructions in this chapter.
Caution:
Don’t touch the gears
inside the printer.
Never use alcohol or
thinner for cleaning; they
can damage the printer
components and case.
Don’t use a hard or
abrasive brush.
Don’t get water on the
printer components.
Don’t spray lubricants or
oils inside the printer.
Caution:
Don’t remove the ink
cartridges before
transporting the printer;
you can damage the
printer.
hw_ch4.fm5 Page 7 Friday, July 25, 1997 10:00 AM