Filter
Top Products
Basic Operations 117
Feed Adjustment
This menu is used when banding (horizontal banding, tint unevenness, or stripes) is
detected in printing results.
This menu provides two modes: Auto and Manual.
❏ Auto: The printer reads adjustment patterns using the sensor while printing the
patterns, and makes adjustment automatically.
❏ Manual: You need to visually check the printed adjustment patterns, and specify the
optimal adjustment values. Use this if graininess or misalignment occurs when using
Auto.
The approximate maximum length of the media required to print the test pattern is given
below. The amount of media used varies with the printer model and the media system
used.
S70675, S50675
S30675
When making Feed Adjustments, see “Precautions regarding settings” on page 111.
1. Check that the printer is ready, and load the media according to the actual usage
conditions.
When using the Auto Take-up Reel Unit, attach the media to the Auto Take-up Reel
Unit. See “Loading and Exchanging Media” on page 38 and “Using the Auto Take-up
Reel Unit” on page 92.
2. Press the Menu button to display the setup menu.
3. Use the d/u buttons to select Media Setup, and press the Z button.
Auto Manual
Standard roll media system Approx.
987 mm
Approx.
1170 mm
Heavy Roll Media System Approx.
1116 mm
Approx.
1170 mm
Auto Manual
Standard roll media system Approx.
1061 mm
Approx.
1170 mm
Heavy Roll Media System Approx.
1190 mm
Approx.
1170 mm