Filter
Top Products
Introduction 16
3 Cutter groove
Pass the blade of a cutter (not included) down this groove to cut media.
4 Pressure rollers (high)
There are ten rollers in total; the high pressure rollers are the two on the outside edges. They press down on the edges of the
media when transparent or white film is used and during ink layering.
See “Positioning the Pressure Rollers and Media (S70675, S50675)” on page 40.
See “Cleaning Inside the Printer (Daily)” on page 155.
5 Pressure rollers (low)
There are ten rollers in total; all of which are low pressure rollers apart from the two on the outside edges. They press down
on the media during normal printing (excluding transparent or white film and ink layering). The number used varies with the
width of the media.
See “Positioning the Pressure Rollers and Media (S70675, S50675)” on page 40.
See “Cleaning Inside the Printer (Daily)” on page 155.
6 Platen heater
The platen heater ensures that the ink adheres evenly.
See “Heating & Drying” on page 114.
See “Cleaning Inside the Printer (Daily)” on page 155.
7 Wiper cleaner
The wiper cleaner removes ink from the wiper. It is included in the maintenance kit and needs to be replaced about once
every three months.
See “Replacing the Wiper and Wiper Cleaner” on page 168.
8Caps
Except during printing, these caps cover the print head nozzles to prevent them drying out. We recommend that this unit be
cleaned at the end of each workday.
See “Regular Cleaning” on page 137.
9Wiper
The wiper removes ink from the print head nozzles. We recommend that this unit be cleaned once a week. It is included in the
maintenance kit and needs to be replaced about once every three months.
See “Regular Cleaning” on page 137.
See “Replacing the Wiper and Wiper Cleaner” on page 168.
10 Flushing pad
Ink is discharged onto this pad during flushing. It is It is included in the maintenance kit and needs to be replaced about once
every three months.
See “Replacing the Flushing Pad” on page 172.