Filter
Top Products
Basic Operations 97
For the subsequent steps, see the next section or “Take up with the printed side facing in”
on page 102.
Take up with the printed side facing out
1. Cut the paper tape approximately 60 cm (24 inches) in length, and paste it
approximately in the center of the media using adhesive tape.
2. Hold down the u button until the tip of the tape reaches the center of the pipe.
Important:
Once part A is hidden, do not turn the handle any further. Failure to observe this
precaution could damage the roll core holder. If part A is still visible even after the
handle has been turned fully, rewind the handle. Then loosen the left roll core holder
fixing screw and reattach the roll core.