Filter
Top Products
Basic Operations 38
Chapter 2
Basic Operations
Loading and Exchanging Media
The process for loading media varies with the model of printer or type of media feeding unit
used. Choose the method suited to your particular setup.
Using the S70675 or S50675
Positioning of the pressure rollers depends on the printing type or media width. The media
loading process varies based on the positioning of the pressure rollers. Therefore, check
the positioning of the pressure rollers in advance.
See “Positioning the Pressure Rollers and Media (S70675, S50675)” on page 40 and
“Loading Media - S70675/S50675” on page 41.
Using the S30675
See “Loading Media - S30675” on page 65.
Notes on Loading Media
Whenever you attempt to load the media, check the following cautions beforehand.
For information on the media that can be used in the printer, see “Supported Media” on
page 235.
c
Caution:
❏ The heaters and media holding plates may be hot; observe all necessary precautions.
Failure to observe the necessary precautions could result in burns.
❏ Be careful not to trap your hands or fingers when opening or closing the front cover.
Failure to observe this precaution could result in injury.
❏ Do not rub your hands along the edges of the media. The edges of the media are sharp
and can cause injury.
❏ Because the media is heavy it should not be carried by one person.