Filter
Top Products
BlackDiamond 8800 Series Switches Hardware Installation Guide
119
8 Installing BlackDiamond 8800 Series Module
Options
This chapter includes the following sections:
● Installing an S-POE Daughter Card on page 119
● Installing an Option Card in the MSM-48c on page 122
This chapter describes how to install the following optional components on BlackDiamond 8800 series
modules:
● S-POE daughter card on the G48Tc or G48Te2 I/O module
● S-G8Xc or S-10G1Xc port option card in the MSM-48c module
Installing an S-POE Daughter Card
The S-POE daughter card adds PoE functionality to the ports on a G48Tc or G48Te2 I/O module.
You must remove the I/O module from the BlackDiamond 8800 series switch before you install the
S-POE card.
You need the following tools and equipment to install an S-POE card:
● ESD-preventive wrist strap
● #2 Phillips screwdriver
● 3/8-inch flat-blade screwdriver
To install the S-POE daughter card:
1 Attach the ESD-preventive wrist strap to your bare wrist. If the metal end is not already connected,
connect it to the ground receptacle at the top left corner of the chassis.
2 Remove the I/O module from the BlackDiamond 8800 series switch, following the instructions in
“Removing a BlackDiamond 8800 Series Module” on page 109. Set the module on an ESD-preventive
work surface.
3 Identify the daughter card connectors on the I/O module (see Figure 70).