Filter
Top Products
Installing Power Supply Units in the BlackDiamond 8800 Series Switches
BlackDiamond 8800 Series Switches Hardware Installation Guide
92
Figure 51: Inserting an AC PSU into the Power Supply Bay
4 Secure the AC PSU in the power supply bay by pushing down on the locking handle until it clicks
into place.
5 If you are replacing a power supply, you do not need to unplug the AC power cord. For a newly
installed power supply, connect the AC power supply cord:
a If necessary, remove the power cord retaining bracket as described in Chapter 3, “BlackDiamond
AC Power Cord Retaining Brackets.”
b Connect the new AC power cord to the AC input on the front of the switch and to the wall outlet
on the other end. Then re-install the power cord retaining bracket.
c Re-install the power cord retaining bracket as described in Chapter 3, “BlackDiamond AC Power
Cord Retaining Brackets.”
To install additional Extreme Networks AC PSUs, repeat steps 2 through 5.
NOTE
Leave the ESD strap permanently connected to the switch, so that the strap is always available when you need to
handle ESD-sensitive components.
Removing or Replacing an Extreme Networks AC PSU
CAUTION
The AC PSU may be hot to the touch; use thermal protective gloves when handling the PSU during removal.
EX_174