Filter
Top Products
Installing an Option Card in the MSM-48c
BlackDiamond 8800 Series Switches Hardware Installation Guide
123
Figure 74: Inserting the Option Card
6 Release the hot-swap prevention latch and verify that the option card has engaged the alignment
pins and connector at the back of the card.
7 At the back of the option card, align and finger-tighten the captive retaining screws to secure the
card in place (Figure 75).
Figure 75: Securing the Option Card
8 Re-install the MSM-48c, following the instructions in “Installing a BlackDiamond 8800 Series
Module” on page 102.
Leave the ESD-preventive wrist strap permanently connected to the switch so that it is always available
when you need to touch ESD-sensitive components.
Option card
MSM48c_hsp-latch
Option card
Tighten retaining
screws
MSM48cOptionCarda