Filter
Top Products
Lockit Lacing Brackets
The included Lockit lacing brackets secure the HDMI cables to the rear panel connectors
as shown. The configuration of the HDMI connectors on the MPS601 rear panel require
using a top mount (HDMI output) and a stacked side mount (HDMI inputs 3 and 4 or
inputs5and6) installation to secure the four inputs and single output.
1. Loosen the HDMI connection mounting screw from the rear panel enough to allow the
LockIt lacing bracket to be placed over it.
NOTE: Do not remove the screw.
2. Place the LockIt lacing bracket on the screw and against the HDMI connector, then
tighten the screw to secure the bracket.
3. Plug the HDMI cable into the panel connection
4. Loosely place the included tie wrap around the HDMI connector and LockIt lacing
bracket. Hold the connector securely against the lacing bracket and tighten the tie
wrap, then remove any excess length.
2
4
3
3
3
3
Side Stacked
3
Top
HDMI
11
2
2
3
3
4
4
Figure 11. Lockit Lacing Bracket Installation
A single LockIt bracket can be used to secure two HDMI connectors in a stacked
configuration as shown below.
2
4
3
3
3
3
Side Stacked
3
Top
HDMI
11
2
2
3
3
4
4
Figure 12. Lockit Lacing Bracket Examples
MPS601 • Installation 9