Filter
Top Products
Cabling the MPS601 Switcher
The switcher can be connected to asmany as six input devices (RGBHV and HDMI). It can
output to one HDMI device or display. Follow the steps below and the installation example
(see Figure 1 on page2).
1. Turn off power to the switcher and all devices that will be connected to it.
2. Mount the switcher (see Mounting Options on page44).
3. Attach up to two analog RGBHV, and four HDMI (or DVI-D with appropriate adapters)
sources (see Connections on page4).
4. Connect the HDMI output to a compatible display device (see Connections on
page4).
5. For analog audio input, connect audio sources to the corresponding audio inputs of the
RGBHV video inputs (see Connections on page4).
6. Connect a control PC or controller to the switcher using:
a. The rear panel RS-232 port and a 3-pole captive screw connector (see Remote
Control Port (RS-232) on page18).
b. The front panel USB configuration port (see Front Panel Configuration Port on
page19).
7. Power up the input and output devices, then connect power to the rear AC connector
of the switcher.
MPS601 • Installation 10