Filter
Top Products
SW2 DP • Reference Information 28
28
28
28
Mounting on a rack shelf
You can mount the SW2 DP to a rack shelf that is at least 3 inches deep. See “Accessories”
on page 26 for a list of available rack shelf kits and their part numbers.
1. If feet were previously attached to the bottom of the unit, remove them.
2. Mount the switcher on the rack shelf, using two 4-40 x 3/16 inch screws in opposite
(diagonal) corners to secure the unit to the shelf (see figure 21).
3. Install blank panels or other units on the rack shelf as desired.
4. Install the shelf in the rack.
Use 2 mounting holes on
opposite corners.
(2) 4-40 x 3/16"
Screws
1U Universal Rack Shelf
Front false
faceplate
uses 2
screws.
1/2 Rack Width Front False
Faceplate
Figure 21. Mounting an SW2 DP Switcher on a Standard 9.5-inches Deep Rack
Shelf
Back of the rack mounting
The SW2 DP can also be mounted vertically to the front or rear rack supports, using the
optional MBB 100 Back of the Rack Mounting Kit as follows:
1. If rubber feet were previously attached to the bottom of the unit, remove them.
2. Remove the two screws from each side of the switcher. Retain the screws for possible
later reassembly.
3. Attach the brackets to the sides of the unit, using the longer screws included in the
mounting kit.