Filter
Top Products
SW2 DP • Reference Information 30
30
30
30
Figure 24. Preparing the SW2 DP Switcher for Under-furniture Mounting
4. Hold the unit with the attached brackets against the underside of the table or other
furniture. On the mounting surface, mark the location of the screw holes for each
bracket.
5. Drill 3/32 inch (2 mm) diameter pilot holes, 1/4 inch (6.3 mm) deep, into the mounting
surface at the marked screw locations.
6. Insert #8 wood screws into the four pilot holes. Tighten each screw into the mounting
surface until slightly less than 1/4 inch of the screw head protrudes.
7. Align the centers of the slots in the brackets with the mounting screws and place the
unit against the surface, with the screw heads through the bracket slots.
8. Slide the unit slightly forward or back, then tighten all four screws to secure it in place.