Filter
Top Products
Step 10
If the right edge of the roll media is
near the guide line (holes), put the hold
lever down. At this time, check and
bear in mind where the edge of the roll
media is in relation to the guide line.
Close the cover. The head will move
automatically to detect the size of the
media.
Step 11
During media detection, the roll media will return parallel to the guide line.
Check again the position of the right edge of the roll media after media detec-
tion. If it is almost over the same line as the position of the edge of the media
that was checked before the cover was closed, then the media setting is a
success.
If the position of the edge of the media after media detection is offset from the
position of the edge of the media before closing the cover, then repeat the
loading of the media from step 8.
Step 1
After printing has finished, open the cover, put the hold lever up
and re-roll the roll media.
Step 2
Go to the back of the printer and press the scroller lock lever as
you lift up the right side of the scroller, then slide the scroller to
the right and take it out.
45
RJ-6000 Series USER GUIDE Basic Edition
Loading the Media
Loading Roll Media
Preparing for Printing
Con f i rmPape rK i nd
Plot OK
Remove while
pressing the
scroller lock
lever.
NOTE
Removing roll media