Filter
Top Products
• Make sure the power to the printer and to the computer is
switched off when you connect the printer and computer.
• For optimum output, please use a cable recommended by
Mutoh. If some other cable is to be used, select one by refer-
ring to "Centronics (Bi-directional Parallel Interface: IEEE1284
compatible) Specifications" on page 103.
The printer can use the Centronics interface (IEEE1284 compatible, Nibble,
ECP). Connect to the printer as shown in the following diagram with an inter-
face cable (option) for the connection system you will use. Connect to the host
computer with another interface cable.
• The use of an unnecessarily long cable may affect data trans-
mission. Interface cables should be as short as possible.
• An Ethernet board RJ-ETH13TX (for networking) is available as
an optional extra. Installation is explained "Installation of
options, Network interface board installation" in the separate
Functions Edition of the User Guide.
Connecting the Interface Cable
48
RJ-6000 Series USER GUIDE Basic Edition
CAUTION
NOTE
Board Box
Interface Cable (option)
Interface Connector
Cable Clamp To computer
NOTE