Filter
Top Products
Changing Configuration Options
User’s Manual 8-33
SETUP MODE
<TEAR-EN>
0 SEC
1 SEC
2 SEC
4 SEC
6 SEC
Specifies the offset time when tearoff is enabled.
The offset time is measured from when data transfer stops
to when the printer performs automatic tearoff feed. If the
printer receives data again within the offset time, the
printer does not perform automatic tearoff feed. In some
application programs, data transfer may stop temporarily
because of internal processing. This setting can prevent
undesired tearoff feed by causing the printer to wait for up
to 6 seconds each time data transfer stops.
<CUTLOAD>
AUTO
B
UTTON
Specifies how cut sheets are loaded using the front table.
Cut-sheet paper is automatically loaded within a certain
time after paper is loaded.
Cut-sheet paper is loaded by pressing the LOAD button
(or LOAD/UNLOAD button).
The <LOADTIM> item is printed when AUTO is specified for the <CUTLOAD> item.
<LOADTIM>
0.5, 1.0,
1.5, 2.0,
2.5, 3.0 SEC
Autoload start time.
Autoloading starts when this time passes after cut-sheet
loading.
<DECODE>
DIRECT
QUEUED
Specifies the timing of command decoding.
The printer decodes certain commands right after receiving
data.
Example:
ESC SUB I, ESC CR P (DPL24C+)
ESC Q # (IBM XL24E)
The printer decodes commands after storing all data
(including commands) in the input buffer. This speeds
data reception because the printer needs no decode time
during data reception.
<ON-LOAD>
OFF LINE
ONLINE
Printer status after loading paper in offline mode.
Remains offline after paper loading.
Goes into online after paper loading.
Table 8–6 CONFIG options (Continued)
CONFIG item Options Description
DL6400/6600 Book Page 33 Thursday, September 21, 2000 7:52 PM