Filter
Top Products
182
8.1 Scanner Settings
■ Settings
Using the Software Operation Panel, you can configure the following settings for the scanner connected to the PC.
［Device setting］
ATTENTION
In View Only mode, the Software Operation Panel cannot be set. For
details on "View Only mode", refer to "Password Setting" on page 175
Item Explanation Selectable parameter Default
Page Counter
(Consumables
counter)
For evaluating the consumable replace-
ment cycle or cleaning cycle.
Use this function to reset the counters
after replacing consumables or the
cleaning.
Refer to “5.1 Consumables and
Replacement Cycle” on page 120.
After Cleaning/Pad/Pick roller/Sepa-
rator Roller/Brake roller/Remaining
ink level (only for the imprinter
option)
-
Power saving Select the waiting time before entering
the Power saving mode.
Refer to “8.2 Power saving setting”
on page 187.
Setting range 15 to 55 minutes (set in
steps of 5 min.)
15 min.
Offset setting Adjust the start position for the docu-
ment scanning.
Refer to “8.3 Offset/Scan scale” on
page 188.
Left right: setting range -2 to 3mm
(set in 0.5mm steps)
Up down: setting range -2 to 3mm (set
in steps of 0.5mm)
left right
0mm
up down
0mm
Vertical magnifi-
cation Adjustment
Adjust the magnification in the feed-
ing direction.
Refer to “8.3 Offset/Scan scale” on
page 188.
Setting range -6.3% to 6.3% (set in
0.1% steps)
0%