184
8.1 Scanner Settings
Dropout color
“Section 8.7”
Drop out a preselected color for the scanned
image. (Binary black & white/grayscale
mode only)
Red/Green/Blue/None Green
Pre-Pick
“Section 8.8”
To give a higher priority to processing
speed, select [Yes], if not, select [No].
Yes/No Yes
Page Edge Filler
(Automatic Page
Size Detection)
“Section 8.9”
Fill the end sections of a specified-mm-wide
with white when the paper size is automati-
cally detected.
The end sections of a specified-mm-wide are
filled with white.
Top/Left/Right/Bottom: 0 to
7.5mm (can be set in incre-
ments of 0.5mm)
(A: Image area B: Filled
area
A+B: Area to be output)
Top/Bottom/
Left/Right:
0mm
Document check
area specifica-
tion for Multifeed
Detection
“Section 8.4”
Selected range: This is checked to make fol-
lowing checking area specification effective.
Selected range Not checked
Enable/Disable: Specifies whether left/mid-
dle/right each ultrasonic sensor is enabled or
disabled.
Enable/Disable Invalid
Start: The start point of the check area in
length (mm) from top edge of the document
is specified.
0 to 510 mm, with 2 mm incre-
ment
0 mm
End: The end point of the check area in
length (mm) from top edge of the document
is specified.
0 to 510 mm, with 2 mm incre-
ment
0 mm
Intelligent Multi-
feed Function
“Section 8.10”
“Section 3.12”
When a fixed size of paper is pasted on the
same location in multiple sheets, the scanner
can memorize the size and location of the
pasted paper so it will not be detected as a
multifeed. To use this function, you need to
select [Check Overlapping] as the multifeed
setting by the procedure described in
“Section 3.7” or “Section 8.4” in advance.
Manual mode/Auto mode 1/
Auto mode 2
Manual mode
Specify whether or not to remember the
multifeed pattern at power-off.
Remember/Do not remember Do not
remember
Number of paper
feeding retries
“Section 8.11”
This is specified to decrease picking retry
times for earlier jam detection.
1 to 12 times 12 times
Item Explanation Selectable parameter Default
A
B