Filter
Top Products
26
2.7 Setting up the Stacker
3. Move your hands away from the stacker slowly.
⇒ The stacker will be fixed in a horizontal position.
<Changing Stacker table motion>
Thin paper sometimes curles when it is ejected to the stacker. This method may be effective to improve the
stacking capability by fixing the stacker hight in the appropriate position.
1. Close the scanner driver dialog box if it is displayed on the PC monitor.
2. Press both Hopper Height buttons on operator panel ( and ) for
more than 2 seconds.
⇒ Every time this is done, the stacker table moves between the lowest position and the
position little a bit above. Set the stacker table at the position little a bit above the lowest
position.
HINT
• When set to the “bottom edge alignment” position, the stacker will automat-
ically adjust its height according to its load.
• When set to the “Bottom edge alignment” position, the stacker’s maximum
load will be 500 sheets.
ATTENTION
• On both sides walls of the stacker, photo sensors are installed to detect
document height on the stacker. Make sure these sensors are not
blocked.
• The stacker may move up or down when the scanner is in the ready sta-
tus up or when scanning starts. Do not touch the stacker or place any-
thing on it at those times.
Send t
o
Powe
r
Thin
Photo sensors