Filter
Top Products
212
8.20 SCSI Bus Width
8.20 SCSI Bus Width
When using the SCSI-connected scanner, you can select a data transfer width.
Configure the settings for the SCSI Bus Width as follows:
1. Start up the Software Operation Panel.
Refer to “8.1 Scanner Settings” on page 173.
2. Select [Device Setting 2] from left side list in the window, and select [SCSI
Bus Width] from its lower level.
3. Select either 16 bit or 8 bit.
ATTENTION
For Kofax VRS, this setting is not displayed. The SCSI Bus Width is auto-
matically set to [8 bit].
ATTENTION
To use SCSI cards and/or SCSI cables that do not support Ultra Wide SCSI,
select “8 bit”.