Fujitsu SPFC-T901-DGFX-1 Laptop User Manual

Open as PDF

of 140

Troubleshooting and tips

Error messag e/cause Resolution

System CMOS checksum bad - default conﬁguration

used

The system conﬁguration information is

incorrect.

► Switch the notebook off.

► Switch the notebook on.

► Press the function key

to acces

sthe

BIOS Setup.

► In the BIOS Setup, select the Exit menu.

► Select the entry Load Setup

Defaults.

► Select OK and press the Enter key.

Extended memory failed at offset: xxxx Failing Bits:

zzzz zzzz

When testing the extended memory an error has

resulted at the address xxxx.

► Check whether the additional memory

module has been inserted correctly.

Failure Fixed Disk n

The settings of the hard disk drive are incorrect.

► Start the BIOS Setup (Primary Master

submenu) and select the correct settings.

Keyboard controller error

► Switch the notebook off with the O N /O FF

switch.

► Wait 3 - 5 seconds and switch on the

notebook again.

Keyboard error

If you are using an external keyboard:

► Check the connection and reboot the

notebook.

nn Stuck key

► Make sure that no key is pressed.

Operating system not found

► Check in the B

IOS Setup whether your hard

disk has bee

n set correctly.

► Make sure that the operating system is

installed on the corresponding drive.

Press < F1> to resume , <F2> to SETUP

This error message appears if an error occurs

during the self-test before starting the operating

system.

► Press the

function key to start the

operating system.

► Press the function key

to access the

BIOS Setup.

Previous boot incomplete - Default conﬁguration

used Due to an error during the previous system

boot, default values were used for certain

settings. Check the settings in the BIOS Setup.

► Press the

function key when prompted

to do so.

Real time clock error