Filter
Top Products
Security functions
Security
SmartCard SystemLock Item Specific Help
SmartCard SystemLock Installed
Uninstall: [Enter]
BIOS Recovery: [Allowed]
SmartCard and Pin [Always required]
SmartCard Initialization
Admin SmartCard [Enter]
SuperUser SmartCard: [Enter]
User SmartCard: [Enter]
Service SmartCard: [Enter]
SmartCard Configuration
Change PIN: [Enter]
Change PUK: [Enter]
Unblock SmartCard: [Enter]
Allows to deactivate
The smartcard security.
ATTENTION:
Always check the BIOS
password settings after
uninstalling
SystemLock.
NOTICE:
Reinstalling a SinglePC
implies re-initializing
all of your smartcards
► For security reasons, the preset PUK should always be changed before removing
the new SmartCard. To do this, unde r SmartCard Configuration, select the option
Change PUK, press the Enter key and input the new PUK.
► First enter the preset PUK.
Enter the PUK:
New Sma rtCards have a preset PUK (see above).
You will need to know the PUK assigned to the SmartCard if you want to
re-initialise a previously initialised SmartCard.
► Enter the PUK.
When the following appears:
• ACCESS DENIED = You have entered an invalid PUK. After six failed attempts,
the SmartCard will be blocked and can no longer be used.
► Enter the n ew PUK as follows.
Enter new PUK:
Confirm new PUK:
A number with 4 to 8 digits is acceptable for the new PUK. For security
reasons, we recommend that you change the PUK for every SmartCard,
and use an 8-digit number each time.
► Re-ente r the new PUK to confirm.
When the following appears:
• PIN/PUK do not match = You have confirmed the PUK incorrectly. You will then
be requested to re-enter and reconfirm the new PUK.
F5,f
unctionkey
F6,f
unctionkey
F7,f
unctionkey
F8,f
unctionkey
F9,f
unctionkey
F10,
functionkey
Instructions on how to initialise an additional SmartCard can be found in Section
"
Carrying out administrator functions", Page 91.
88 Fujitsu Technology Solutions