Filter
Top Products
MAGNUM 6K SWITCHES, MNS-6K USER GUIDE
• Same Duplex and
• LLL - enable
The necessary commands are
Syntax stp – STP Configuration mode
Syntax stp <enable|disable> - Start (Enable) or stop (Disable) STP
Syntax set stp type=<stp|rstp> - set the spanning tree protocol to be IEEE 802.1d or 802.1w
(Spanning Tree Protocol or Rapid Spanning Tree Protocol)
Syntax show active-stp – Display which version of STP is currently active
Syntax show s-ring – show the status of S-Ring status and configuration
Syntax s-ring <enable|disable> - enable or disable S-Ring capabilities
Syntax s-ring learn – start the learning process to discover the ring and the ports which make up the S-
Ring
Syntax s-ring add port=<port1,port2> - define ports which make up the S-Ring ports. Note as
discussed earlier, you can create multiple S-Rings on a switch
Syntax s-ring del port=<port1,port2> - remove the switch from S-Ring topology by eliminating the
end ports on the switch
Magnum6K25(stp)## show s-ring
S-Ring Status:
sRing Status: DISABLED
Port 1 Port 2 Status
Magnum6K25(stp)## s-ring enable
S-RING Enabled.
Magnum6K25(stp)## show s-ring
S-Ring Status:
sRing Status: ENABLED
Port 1 Port 2 Status
Magnum6K25(stp)## s-ring add port=1,7
183