Filter
Top Products
Drives 39
To replace a failed drive:
1 Use the Gateway™ server management utilities to determine which drive
needs to be replaced.
2 If the drive carrier is locked, use the hex key to unlock the carrier. Locked
drive carriers show a red flag in the slot on the carrier handle.
3 Remove the drive from the drive bay by pressing down on the carrier
handle and rotating the handle out and down from the front of the server.
Caution Before you remove the failed drive, use the appropriate
software and utilities installed on the system to stop all
activity on the failed drive. Instructions for using the
software are provided by the software manufacturer.
Failure to do so may destroy the data on the drive.
8508366.book Page 39 Tuesday, October 23, 2001 11:29 AM