Filter
Top Products
78
Chapter 4: Installing Components
www.gateway.com
6 Locate the old battery on the system board and note its orientation. You
will need to install the new battery the same way.
7 Push the battery retention clip away from the battery until the battery lifts
up, then remove the old battery. You can use a screwdriver to help lift the
battery.
8 Make sure that the positive (+) side of the new battery is facing up, then
press the new battery into the socket until it snaps into place.
9 Follow the instructions in “Closing the server case” on page 48.
10 Turn on your server, then press F2 when the Gateway logo screen appears
during startup.
11 Restore any BIOS settings that you wrote down in Step 3.
12 Save all your settings and close the BIOS Setup utility.
CMOS
battery