Filter
Top Products
System Error Codes
2-10
HP DesignJets 1050C and 1055CM Printers Service Manual
System Error: 060309
Problem
Description:
Problem with setting the Voltage of the Printheads.
Corrective Action: Try the following:
Remove ALL the Printheads and clean the flex contacts on the
Printheads and in the Carriage Assembly (Refer to Chapter 2).
Perform the Electronic Systems Test ⇒ Page 4-5.
Replace ALL the Printheads.
Replace the Trailing Cable ⇒ Page 8-39.
Replace the Carriage Assembly ⇒ Page 8-44.
If the Error Code continues, replace the Electronics Module ⇒
Page 8-25.
WARNING Only replace one component at a time and check if the error has
gone before replacing another component. Using this procedure
you will be able to determine exactly which component failed.
System Error: 06030A (Continuable)
Problem
Description:
Error in finding the Mark Encoder.
Corrective Action: Try the following:
Clean the Mark Encoder if necessary (use the Overdrive Cleaning
Utility to position the Mark Encoder ⇒ Page 4-37).
Clean the Line Sensor (located on the Carriage Assembly).
Perform the Line Sensor Calibration ⇒ Page 5-9.
Perform the Mark Encoder Calibration ⇒ Page 5-13.
Replace the Trailing Cable ⇒ Page 8-39.
Replace the Carriage Assembly ⇒ Page 8-44.
If the Error Code continues, replace the Electronics Module ⇒
Page 8-25.
WARNING Only replace one component at a time and check if the error has
gone before replacing another component. Using this procedure
you will be able to determine exactly which component failed.