Filter
Top Products
System Error Codes
2-11
HP DesignJets 1050C and 1055CM Printers Service Manual
System Error: 06030B
Problem
Description:
The Ambient Temperature measured is out of the normal range.
Corrective Action: Try the following:
Make sure that the Ambient temperature is within the allowed
range (between 0 and 55 Degrees Centigrade).
Replace the Electronics Module ⇒ Page 8-25.
System Error: 070100 XXXXXXXX (Non-Continuable)
Problem
Description:
Firmware Error.
Corrective Action: Power the Printer OFF and ON again to see if the System Error
disappears.
If the Error Code reappears, then report the error to the HP response
Center or the nearest HP Support Office, stating the following
information.
Model and Serial Number of the printer.
Which firmware revision the printer is using (See Note below).
Check firmware in Utilities / Statistics / Code rev.
The complete error number (See Note below).
The Service Configuration Print ⇒ Page 1-19.
The Current configuration sheet.
Which software application the customer is using (name, version, etc.).
NOTE When reporting the System Error Code, make sure that you
supply the full Error Code (including the last 8 numbers where
applicable) and the firmware version. Without this information,
HP Support Personnel cannot help you.