Filter
Top Products
restore factory defaults
27
to align the print cartridges when prompted
1 Press ENTER on the front panel.
The HP Officejet prints a text page that contains instructions and an align
cartridges page that contains test patterns.
2 Following the instructions on the text page, place the align cartridges (test
pattern) page face down in the ADF. Adjust the paper-width guides to
ensure that the page feeds in straight. Press E
NTER.
The HP Officejet aligns the cartridges and displays the message
“Alignment Complete.” Discard or recycle the text page and align
cartridges page.
to align the cartridges at any other time
1 Press SETUP until 5:Maintenance appears, and then press ENTER.
2 Press until 2:Align Print Cartridges appears, and then press E
NTER.
The HP Officejet prints a text page that contains instructions and an align
cartridges page that contains test patterns.
3 Following the instructions on the text page, place the align cartridges (test
pattern) page face down in the ADF. Adjust the paper-width guides to
ensure that the page feeds in straight. Press E
NTER.
The HP Officejet aligns the cartridges and displays the message
“Alignment Complete.” Discard or recycle the text page and align
cartridges page.
clean the print cartridges
Use this feature when the Self-Test Report shows streaking or white lines through
any of the colored bars. Do not clean print cartridges unnecessarily. This wastes
ink and shortens the life of the ink nozzles.
1 Press S
ETUP until 5:Maintenance appears, and then press ENTER.
2 Press until 1:Clean Print Cartridges appears, and then press E
NTER.
If copy or print quality still seem poor after you clean the print cartridges,
replace the print cartridge that is affected.
restore factory defaults
You can restore the original factory settings to what they were when you
purchased your HP Officejet. You can perform this process from the front panel
only.
1 Press S
ETUP until 5:Maintenance appears, and then press ENTER.
2 Press until 3:Restore Factory Defaults appears, and then press E
NTER.
The factory default settings are restored.