Filter
Top Products
132
.POWERUP
The .POWERUP event occurs automatically whenever the Terminal
server is powered up. This might indicate a new installation, recovery
from a power loss, or that the unit was moved to a new location.
Example:
Alarm/Event Action Routine Parameters Comments
.POWERUP PHONHOME
This example causes the Terminal server to report to the maintenance
center that the unit has been reset. If desired, someone can then
investigate the reason for the .POWERUP event.
.PPPREQ
This event is triggered when a PPP link is needed to send an SNMP
trap or to send a file via FTP. It is usually associated with the phone
PPP (PHPPP) Action Routine.
Alarm/Event Action Routine Parameters Comments
.PPPREQ PHPPP 5551212 Create the PPP
link.
The telephone number can be specified directly, or any of the default
telephone numbers specified in the system parameters can be
referenced. PHPPP assumes that there is no firewall or security on the
remote access device. If this is not the case, contact your Hewlett-
Packard Service Representative.