Filter
Top Products
Configuration
FRU Configurations
53
Monitor-Type Selection
The built-in graphics in the C Class workstations sup-
port the following two monitors:
• 17-inch, 1280x1024 color monitor (A4032A)
• 20-inch, 1280x1024 color monitor (A4033A)
The monitor type does not have to be changed on the
workstation since the workstation is set up to support
these monitors. However, if for some reason the moni-
tor type needs to change, refer to Chapter 9 of this
book.
NOTICE: Unsupported monitors may “lock up” if they
cannot sync to a scan rate.
Changing the Console to External Terminal
In the event that your console stops displaying to your
graphics device, use the following procedure to display to
console to an external terminal:
1 Turn system power off.
2 Disconnect the PC keyboard connector from the system
rear panel.
3 Connect a serial terminal to the Serial 1 connector (the
top serial connector) on the system rear panel.
4 Power on the system.
The system will now display the console to the terminal
connected to the Serial 1 port. Note that you can use a 9-pin
to 9-pin serial cable (HP F1044-80002) to connect an HP
OmniBook serial port to the workstation.