Filter
Top Products
2. Press the down arrow button to highlight Advanced Fax Setup, and then press OK.
3. Press the down arrow button to highlight Fax Speed, and then press OK.
4. Press the down arrow button to select one of the following settings, and then press OK.
Fax speed setting Fax speed
Fast (33600) v.34 (33600 baud)
Medium (14400) v.17 (14400 baud)
Slow (9600) v.29 (9600 baud)
Cause: The Fax Speed setting might have been set too fast.
If this did not solve the issue, try the next solution.
Solution 2: Check for error messages on the display
Solution: If an error condition exists that is preventing the product from printing faxes, review the display for
information on the error condition. Make sure:
• The product is on. Press the On button to turn on the product.
• The product is set up correctly for faxing. See the printed documentation for more information.
• There is paper loaded in the input tray.
• There is no paper jam.
• The print carriage is not stalled or blocked. Turn off the product, remove any objects that are blocking the
print cartridge carriage (including any packing materials), and then turn on the product again.
• The print cartridge door is closed. If not, close the print cartridge door, as shown below:
NOTE: If the product has an alignment message, you might be able to press the button next to OK to clear
the message and resume faxing.
After you resolve any problems found, the product can begin answering incoming fax calls.
Cause: An error condition was preventing the product from receiving faxes and Backup Fax Reception was
set to Off.
Chapter 13
168 Solve a problem
Solve a problem