Filter
Top Products
4. Press to highlight EMBEDDED JETDIRECT, and then press .
5. Press
to highlight TCP/IP, and then press .
6. Press
to select CONFIG METHOD.
7. Press
to highlight MANUAL, and then press .
8. Press
to highlight MANUAL SETTINGS, and then press .
9. Press
to highlight SUBNET MASK, and then press .
10. Press the
or arrow to increase or decrease the number for the first byte of the subnet mask.
11. Press
to move to the next set of numbers. (Press to move to the previous set of numbers.)
12. Repeat steps 10 and 11 until the correct subnet mask is entered, and then press
to save the
subnet mask.
13. Press Menu to return to the Ready state.
Setting the default gateway
1. Press Menu.
2. Press
to highlight CONFIGURE DEVICE, and then press .
3. Press
to highlight I/O, and then press .
4. Press
to highlight EMBEDDED JETDIRECT, and then press .
5. Press
to highlight TCP/IP, and then press .
6. Press
to select CONFIG METHOD.
7. Press
to highlight MANUAL, and then press .
8. Press
to highlight MANUAL SETTINGS, and then press .
9. Press
to highlight DEFAULT GATEWAY, and then press .
10. Press the
or arrow to increase or decrease the number for the first byte of the default
gateway.
11. Press
to move to the next set of numbers. (Press to move to the previous set of numbers.)
12. Repeat steps 10 and 11 until the correct default gateway is entered, and then press
to save the
default gateway.
13. Press Menu to return to the Ready state.
Disabling network protocols (optional)
By factory default, all supported network protocols are enabled. Disabling unused protocols has the
following benefits:
●
Decreases printer-generated network traffic
●
Prevents unauthorized users from printing to the printer
46 Chapter 3 I/O configuration ENWW