Filter
Top Products
Section 4: AS/400, iSeries Host Set Up
4-9
4.4.2 V3R2 CRTPSFCFG Command.
The CRTPSFCFG command is used to configure AFP for OS/400 V3R2.
Use the following user defined settings to create the AFP description:
A. PSF configuration (PSFCFG). Enter a name or description for the IntelliBar AS Net
printer being configured (ex., M48ASN).
B. Library. Select QGPL.
C. IPDS pass through (IPDSPASTHR). Select *YES to print SCS files (transforms SCS into
IPDS). Select *NO to print only IPDS files.
D. Activate release timer (ACTRLSTMR). Select *NORDYF. This activates the release timer
when there are no spooled files in the output queue with a Ready Status (RDY) after the
last spooled has printed. *NORDYF provides that all RDY files are printed before releasing
the session. *NORDYF does not terminate the writer).
E. Release timer (RLSTMR). Enter a value equal to or greater than the TCP/IP TIMEOUT
setting on the IntelliBar print server. IntelliTech recommends *SEC15. This sets the time
PSF/400 maintains a session with the IntelliBar when there are no Ready Status (RDY)
spooled files.
F. Remote Location name (RMTLOCNAME). Enter the IntelliBar AS Net print server IP ad-
dress.
G. TCP/IP port (PORT). Enter 5001.
H. TCP/IP activation timer (ACTTMR). Enter the number of seconds for PSF/400 to wait for
the IntelliBar printer to respond to an activation request. If the printer will be used only by
one system, use the default value (170 seconds). If the printer will be used by more
than one system, select *NOMAX.
Configure the V3R2 AFP description by typing the following commands on the command line
and completing the recommended settings:
Note. For the RMTLOCNAME (‘0.0.0.0’) entry, enter the Intelli-
Bar AS Net print server IP address.
CRTPSFCFG PSFCFG(M48ASN) IPDSPASTHR(*YES) RLSTMR(*SEC15) TEXT
(<M48 AS Net Printer>) RMTLOCNAME (‘0.0.0.0’) PORT(5001)