Filter
Top Products
ENWW Using the Embedded Web Server 131
Password,
Confirm Password
Specify an EAP/802.1X password (up to 128 characters
maximum) for this device. Enter the password again in the
Confirm Password field to ensure it was properly entered.
Server ID Specify the Server ID validation string that identifies and
validates the authentication server. The Server ID string is
specified on the digital certificate issued by a trusted
Certificate Authority (CA) for the authentication server. The
entry may be a partial string unless the Require Exact
Match checkbox is enabled.
Encryption Strength Specify the minimum encryption strength that can be used
during communications with the authentication server. You
may select Low, Medium, or High encryption strength. For
each encryption strength, ciphers are specified to identify
the weakest cipher allowed.
Early browsers may only support 40-bit (Low) encryption
levels.
CA Certificate To validate the authentication server’s identity, a CA (or
“Root”) certificate must be installed on the print server. This
CA certificate must be issued by the Certificate Authority
who signed the authentication server’s certificate.
To configure or install a CA certificate, click Configure.
Authentication
Behavior:
Reauthenticate on
Apply
Enable (check) or disable (clear) this checkbox to control
authentication when you click Apply on this page,
assuming valid configuration entries have been made.
Note: This parameter does not apply to security or other
configuration wizards. Changes to parameters through
a wizard will always cause the print server to
reauthenticate.
If disabled (default), the print server will not attempt
reauthentication unless configuration changes cause the
print server to disconnect and reconnect to the network.
If enabled, the print server will always try to reauthenticate
using the configuration values set.
Table 4.10 802.1X Configuration Settings
Item Description